MHC2300-4N88T1 Clamp Cap

MHC2300-4N88T1 Clamp Cap Allowable Capacity 55 Tons

MAGNUM® MHC2300-4N88T1 Clamp Caps consist of a collar tube with threaded bolt hole for clamp connection to MAGNUM® helical piles and steel bearing plate for embedment in cast-in-place reinforced concrete. MAGNUM® products are manufactured in the USA according to our ISO 9001 approved quality program. Structural capacities are developed according to AISC 360 and ACI 318 considering an average design life of 75 years for bare steel in most soil conditions. Hot-dip galvanizing is available upon request. Design and detailing of the structure to which bearing plate cap is embedded in varies by project and is the responsibility of the registered design professional.

Description

After installation of a MAGNUM® Helical Pile to the correct depth, torque, and capacity, cut-off the pile shaft at the proper elevation. Place the cap over the shaft and secure with (1) 3/4” fine thread bolt. Tighten to specified torque. Ensure direct bearing of plate on shaft. Place reinforcing steel, cast concrete and consolidate around the pile cap per project requirements. * Plate must directly bear on shaft for compression capacity shown. ** Bolt must be new, clean, dry and free from any dust, rust or paint & threaded hole must be clean, dry and free of any surface dust, rust, paint or galvanizing for tension capacity shown. Manufacture applied lubricating wax on bolts is acceptable.

Additional information

Allowable Compression / Tension	55 Tons / 1 Ton
Ultimate Compression / Tension	110 Tons / 2 Tons
Helical Pile Compatibility	https://magnumpiering.com/products/mh429u-helical-piles/ https://magnumpiering.com/products/mh434u-helical-piles/