MHC1093-3BR1 Pipe Support Cap Allowable Capacity 6 Tons

MHC1093-3BR1 Pipe Support Cap (steel cap)

Complete installation of a MAGNUM® Helical Pile to the correct depth, torque, and capacity. Cut off the pile at the proper elevation. Note, pile must be set at +0”/-3.5” from planned elevation. If pile shaft is set higher than this elevation range due to reaching maximum torque or refusal, stop installation and cut-off the pile shaft at the proper elevation. Drill (1) 1-1/16” diameter hole through the shaft using a MAGNUM® drill template, place the cap over the shaft and secure with (1) 1” bolt. Snug tighten nut. Adjust to final elevation by turning plate as required. Tighten set screw to prevent wobble. Place pipe on support and adjust plate as necessary to install the pipe hold down (provided by others). *Pipe Hold Down: Fits single SAE ‘U’ bolts for nominal pipe sizes: 4”, 5”, 6”, 8”, 10”, 12”, 14” & 16”. Contact Magnum sales team for bolt hole pattern.