MHC1100-316 Slab Lift Cap Allowable Capacity 14 Tons
Magnum MHC1100-316 slab lift cap consist of a collar tube with bolt holes for connection to MAGNUM® helical piles and a circular bearing plate with an integrated nut. MAGNUM® products are manufactured in the USA according to our ISO 9001 approved quality program. Structural capacities are developed according to AISC 360 considering an average design life of 75 years for hot-dip galvanized steel in most soil conditions. Bare steel is available upon request. Design and detailing of the structure, to which bearing plate cap is attached varies by project. It is the responsibility of the registered design professional.
Description
Core a hole through the slab slightly larger than the largest helix. Excavate a void large enough to facilitate channel installation. Install a MAGNUM® Helical Pile to the correct depth, torque, and capacity. Cut-off the pile shaft at the proper elevation. Place the pile cap over the shaft. Place the channel under the slab with lifting bolt in place. Tighten the lifting bolt to raise the slab elevation as needed. Fill the void under the slab and core hole with fast-setting, high-strength, non-shrink grout.
Additional information
| Allowable Compression / Tension | 28 Tons |
|---|---|
| Ultimate Compression / Tension | 28 Tons |
| Helical Pile Compatibility | https://magnumpiering.com/products/mh313b-helical-piles/ |
You may also like…
Related products
-
MHC1300-6O1010B3 Bearing Plate Cap Allowable Capacity 56.5 Tons
Download Cut Sheet -
MHC1350-5N6135B1 Gusseted Cap Allowable Capacity 98 Tons
Download Cut Sheet -
MHC1300-6O1111B3 Bearing Plate Cap Allowable Capacity 56.5 Tons
Download Cut Sheet -
MHC1300-12N25B2 Bearing Plate Cap Allowable Capacity 27 Tons
Download Cut Sheet